UC7067REV Ceiling Fan Reverse Module for Hampton Bay

About the Hampton Bay UC7067REV Reverse Module

A failed UC7067REV leaves the reverse button dead while speeds and light keep working. Our replacement restores remote reverse on your fan. Look for UC7067REV on the module's label once the switch housing cover is off. It's a small plug-in module, separate from the receiver, inside the switch housing or canopy.

If UC7067REV is printed on your old module, you're in the right place. Plug it in where the old one was and the reverse button works again.

• Restores remote reverse
• Unplug the old one, plug in the new one
• Works with UC7067-series and FAN28R receivers
• 120V 60Hz

Remotes that use it

Reverse-capable remotes and wall controls send the reverse command through this module, such as the UC7078TR, UC7080T, UC9051GTB wall remote and UC70961TX thermostatic remote with a FAN28R receiver.

Only if your fan had one

This module replaces one that came with the fan from the factory. It can't add remote reverse to a fan that never had it, and it isn't for fans that reverse with a slide switch on the motor housing.

Before you order

• This is NOT a receiver. If the fan runs at only one speed, will not turn on, or the light does not work, the receiver needs replacing, not this module.
• Only for fans that came with a separate reverse module from the factory. It cannot add reverse to a fan that never had one.

Setup & Pairing

Plan on about 15 minutes with the breaker off.

1. Turn off power to the fan at the breaker.
2. Open the switch housing or lower the canopy cover to find the module.
3. Photograph the old module's connection and unplug it.
4. Plug in the new module the same way and secure it.
5. Close everything up, restore power and press reverse to test.

Let the fan stop fully before you test reverse.

In the box: 1 UC7067REV reverse module.