MSZ-HM09NA-U2 Mitsubishi Mini-Split Air Conditioner Remote Control

About the Mitsubishi MSZ-HM09NA-U2 Remote

This is a model-matched remote for the Mitsubishi MSZ-HM09NA-U2. It isn't a universal that needs code hunting; it's ready to run the 9,000 BTU unit's mode, temperature, fan speed, swing, timer and memory straight out of the box.

The model number to look for is MSZ-HM09NA-U2, printed on the indoor unit's label rather than the outdoor condenser. Once the remote arrives, add batteries, aim and press power.

• Slim, about 5.5 x 2.1 inches
• Nothing to program out of the box
• Matched to the 9,000 BTU MSZ-HM09NA-U2
• Full everyday control of the indoor unit

Is it the remote or the unit?

Point the old remote at your phone's camera and press a button while watching the screen. A faint flicker of light means the remote is still sending. Some rear cameras filter infrared, so try the front camera too. No flicker with fresh batteries usually means the remote itself has failed.

Same size in the hand

This remote is a slim white unit, about 5.5 by 2.1 inches and just over half an inch thick. It fits a shirt pocket or a nightstand tray, and the button layout covers mode, temperature, fan speed, vane swing, timer and memory, so there's no learning curve.

Before you order

• Check the whole model number on your label, including the last characters after the final dash. If it isn't exactly MSZ-HM09NA-U2, send us a photo first at (816) 586-8457 or info@fanremotes.com.
• Match your indoor unit's label to MSZ-HM09NA-U2 before ordering.
• Bigger 18k or 24k BTU unit? Choose our E22P88426 instead.

Setup & Pairing

Setup takes about a minute.

1. Load two AAA batteries (not included).
2. Stand where the remote can see the MSZ-HM09NA-U2, then press power; the unit should answer within a second.
3. Choose a mode and set the temperature you want.
4. Listen for the unit's short beep, which most units give when a command arrives.

In the box: replacement remote for the MSZ-HM09NA-U2. Batteries not included.